Thames Valley Saw Service Ltd.

The Saw & Cutter Specialist.

Sash Pro TCT Blades.

Our specialist subject is the sawing of Aluminium sections and solids.

Our range of blades for this is without equal.

SASH PRO:

 

à Very High Cutting Life, usually 3 – 5 times longer than the nearest High Quality competition.

à Low Noise Cutting, typically 85dB, for a better working environment.

à Highest Quality Surface Finish.

à Reduced waste, due to thinnest kerf blades.

à Burr Free Cutting, so no expensive de-burring of Profiles.

à Extensive range of Tooth Types for all applications. (Profiles, Solids, Billets etc)

à The Best “Cost per Cut” ratio.

 

To Contact us:

Phone: 01235 550088, 531640

Fax:     01235 553150

E-mail: sales@tvss.co.uk

 

The main types of geometry are as follows.

D.Type Geometry:                 For Solid material or thick walled sections.

BC5 Geometry:      For smaller solids and medium wall sections.

DX Geometry’s:     For thin walled and fragile extrusions.

Cold Saw:                                For Solid Billet. (Foundry)

 

Within these tooth styles there are several additional choices. Starting with the pitch (number of teeth), and also the type of blade as below.

 

Standard Sash-Pro.

Hyper Critical Blade. Amazing performance.

Stable Saw. The newest, thinnest and most High Performance Blade available today for Profile Cutting.

 

To obtain the very best and most appropriate blade, we would require the following information. The details of the material being cut, the RPM of the blade, and the flange diameter. With these parameters we can advise you the very best blade specification for your particular use.

We are happy to visit and assist you in the best choice of specification for your cutting requirements.

 

The blades run within a very tight tolerance of axial run-out, with the result that noise levels, which is irritating, and has been linked to hearing loss or impairment, has been reduced to the lowest possible level, typically 85dB.

The Carbide grades are also very special, and only available on our Kanefusa blades.

The blade body also exhibits very low vibration, due to the special LS-P slots. These slots create a very stable blade plate, thus the stress is equal throughout the whole blade. This is a critical feature in cutting difficult or fragile aluminium sections.

These blades come with a total guarantee, if they do not give you 100% satisfaction, you are welcome

to return them without question.

 

Sizes available from 180mm – 1200mm, with any bore and Pinhole combination.

                                          

The best Aluminium blades…………